User Manual

Engine maintenance (trained operators)
Introduction
Only operators that are specially trained in engine maintenance are allowed to perform
engine maintenance. Before you can perform engine maintenance tasks you have to put
the engine into the engine maintenance mode.
#
IMPORTANT
Make sure you are specially trained in engine maintenance for this product to prevent
major damage.
Prepare the engine for maintenance
1.
On the operator panel, press the 'System' button.
2.
Press 'Maintenance'.
3.
Press 'Engine maintenance'.
4.
Press 'Start'.
5.
Enter the maintenance PIN and touch 'OK'.
The 'Engine maintenance' window opens.
6.
Touch 'Next' and wait a moment while the engine prepares for maintenance.
#
NOTE
If you are specially trained in engine maintenance, you can now perform maintenance
tasks using the Operator's Maintenance Manual.
#
IMPORTANT
Only continue with the next step after you finished maintenance.
7.
Touch 'Next' to stop the engine maintenance mode.
8.
Touch 'Finish' to stop the preparation procedure.
9.
Press 'Stop'.
Chapter 11 - Maintenance and calibration 353
Engine maintenance (trained operators)