User Manual

15.
When you have finished aligning the rear edge retainer with the marks for the desired
paper size, fasten the rear edge retainer to the outer size change plate with the blue screw
using a coin or something similar.
16.
Make sure that the inside lifter has lowered, and load the remaining paper into the paper
tray.
#
NOTE
When loading paper, make sure that the height of the paper stack does not exceed
20 mm. If the height of the paper stack exceeds 20 mm, the edges of the paper stack
may become curled or creased, and poor print quality may result.
17.
Close the paper tray.
Chapter 9 - Paper, toner, and staples266
Adjust the outer size change plate of the bulk paper module (optional)