User Manual

11.
Fix the rear edge retainer with the blue screw using a coin or something similar.
#
IMPORTANT
There are two screw holes for fastening the rear edge retainer. Make sure that the rear
edge retainer is fastened properly, aligned with the marks for the desired paper size,
to prevent it from being installed at an angle.
12.
Remove the two blue screws on the inner size change plate using a coin or something
similar.
13.
Lift up the inner size change plate.
#
NOTE
Hot air that is blown by the fan may warm the size change plate.
Chapter 9 - Paper, toner, and staples256
Adjust the media size for the bulk media module (optional)