User Manual

#
IMPORTANT
•
Do not load paper into the paper tray that has been previously printed onto, as
this may result in a malfunction or damage to the copier. Always use the special
feeder to feed paper when you want to print onto the back of a sheet of paper that
already has something printed on its front side (2nd side of 2-Sided print).
•
Paper which has been rolled or curled must be straightened out prior to use.
•
Make sure that the height of the paper stack does not exceed the loading limit
mark at the back of the paper tray.
#
NOTE
•
Each paper tray holds approximately 1,000 sheets of paper (80 g/m2 / 22 lb Bond).
•
If there are instructions on the package of paper about which side of the paper to
load, follow those instructions.
•
When the paper is loaded into the paper tray, the side facing down is the one
printed on.
•
If problems occur, such as poor print quality or paper jams, try turning the paper
stack over, and reload it. However, you cannot turn the texture paper and 1-Sided
Coated paper over. Change the new paper.
6.
Lower the paper holder plate.
7.
Gently push the paper tray back into the machine until it clicks into place in the closed
position.
Chapter 9 - Paper, toner, and staples238
Load the media into the paper tray