imageCLASS MF7400 Series Reference Guide

1
2
3
4
5
6
7
8
9
10
11
10-20
PreviousBack Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Place the original on the platen glass.
Description The specified mode requires that the original be
placed on the platen glass, but there is no
original on the platen glass.
Action Place the original on the platen glass.
Platen Glass is dirty.
Description The feeder’s scanning area is dirty.
Action Clean the feeder’s scanning area. (See “Manual
Feeder Cleaning,” on p. 9-5.)
Remove the original from the feeder.
Description The machine cannot scan your original using the
feeder. An original is placed in the feeder and on
the platen glass.
Action Remove the original from the feeder.
Remove the paper from the output tray.
Description Prints from the previous job remain in the output
tray.
Action Remove the prints remaining in the output tray.
Printing automatically resumes.
Replace the toner.
Description Printing is not possible because the toner has run
out.
Action Replace the cartridge. (See “Replacing the
Cartridge,” on p. 9-12.)
Return page 1 to the top, and then press the Start key.
Description Scanning was stopped due to a problem with the
feeder.
Action Arrange the originals in page order with the first
page on top. Place the originals back into the
feeder’s original supply tray, and press (Start).
Set the IP Address. (imageCLASS MF7480/MF7470 Only)
Description This machine is not set with an IP address.
Action Specify the IP Address Settings in TCP/IP Settings
in Network Settings in System Settings (from the
Additional Functions screen), then turn the
machine’s main power off and back on again.
(See “IP Address Settings,” on p. 6-40, or “Set the
Machine for Network Usage (imageCLASS
MF7480/MF7470 Only),” in the Starter Guide.)
There are too many subdirectories.
Description You have exceeded the maximum number of
subdirectory levels allowed.
Action The directory level that you are trying to access
cannot be specified. Specify a different
destination.