imageCLASS MF7400 Series Reference Guide

1
2
3
4
5
6
7
8
9
10
11
6-10
PreviousBack Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
7. In [Printer Name or IP Address], enter the
machine IP address or machine host name 
click [Next].
After the computer has confirmed that there is a machine in which
the entered IP address is assigned, the [Completing the Add
Standard TCP/IP Printer Port Wizard] window appears.
8. Click [Finish].
If the dialog box displays [Additional Port Information Required],
follow the instructions on the screen to search again, or click
[Standard]  click [Canon Network Printing Device with P9100] from
the pull-down list  click [Next].
9. Click [Close] to close the [Printer Ports] dialog
box.
10. In the printer properties dialog box, click
[Configure Port]  click [LPR] under [Protocol] 
enter a print queue in [Queue Name] under [LPR
Settings].
If you want to use Raw, confirm [Raw] under [Protocol] is selected,
and proceed to step 11.
You can specify a print queue in [Queue Name]. The following three
print queues are available:
LP: The machine prints according to its spool settings. Normally
select this option.
SPOOL: The machine prints only after spooling a print job on the
hard disk, regardless of its spool settings.
DIRECT: The machine prints without spooling a print job on the hard
disk, regardless of its spool settings.
11. Click [OK].
12. Click [Close].