imageCLASS MF7280 Sending Guide

Sending Methods
4-23
4
Sending Documents
Delaying a Send Job
The Delayed Send mode enables you to store a send job in memory, and have it
sent at a later time.
NOTE
• You can reserve up to 70 jobs for the Delayed Send. However, the actual number of jobs
that can be reserved may be less than 70, depending on the following conditions:
- If multiple documents are being sent at the same time
- If large documents are being sent
• The number of delayed send jobs which you can reserve may also be reduced if there
are jobs other than Delayed Send, or if there are other factors affecting the specified
destinations.
• Once the delayed documents are sent, the documents are automatically deleted from
memory.
• You can check the status or cancel the transmission of jobs for which a preset send time
has been specified. (See "Using the System Monitor Screen," on p. 1-42, and Chapter 6,
"Checking/Changing the Send/Receive Status.")
1 Press (SEND) ➞ place your originals ➞ specify the
destination ➞ press [Send Settings].
If necessary, see the screen shot in step 2 of "Sending an E-Mail Message," on
p. 4-2.
NOTE
• For instructions on placing your originals, see "Placing Originals," on p. 1-31.
• For instructions on specifying addresses stored in the Address Book, see "Using
the Address Book," on p. 2-2.
• For instructions on specifying addresses not registered in the Address Book, see
"Using the New Address Tab," on p. 2-5.
• For instructions on specifying addresses using the one-touch buttons, see "Using
the One-Touch Buttons," on p. 2-21.
• For instructions on specifying addresses and settings using the favorites buttons,
see "Using the Favorites Buttons," on p. 2-22.
• For instructions on setting the scan mode for your documents, see "Selecting a
Scan Mode," on p. 3-2.