imageCLASS MF7280 Network Quick Start Guide

Connecting the Machine
1-4
Connecting the Machine to a Network
1
Connecting to a Network
Connect the machine’s RJ-45 connector to a hub port using a Category 5 twisted
pair LAN cable.
IMPORTANT
You cannot use the machine as a repeater, bridge, or gateway.
NOTE
• The machine can automatically detect the type of Ethernet (10Base-T or 100Base-TX).
• If you are using a mixed 10Base-T/100Base-TX environment, devices on the network
(hubs, routers, etc.) must support the mixed environment. For more information, consult
your local authorized Canon dealer.
• After connecting the network cable, perform the following operations. (For more
information, see the relevant descriptions.)
- Set the date and time, and System Manager settings. (See Chapter 5, “System
Manager Settings,” in the Reference Guide.)
- Set the network settings. (See the Network Guide.)
- Install a printer driver if necessary. (See Chapter 2, “Installing Software.”)
Hub
Ethernet Cable
PC with
100Base-TX Connector
PC with
10Base-T Connector