imageCLASS MF7280 Network Guide

Setting Up a Computer for Printing/Sending a Fax
3-32
3
Using a TCP/IP Network
3 Install the driver.
Install the driver according to the procedures indicated in the Starter Guide.
NOTE
• The print application will be LPD and the print queue will be set to <LP> if the driver
has been installed according to the above procedures.
• This machine enables you to specify print queues other than <LP>. For details on
print queues and instructions on how to change the settings, see "Changing the
Port after lnstalling the Driver," on p. 3-32.
■ Changing the Port after lnstalling the Driver
1 Install Canon LPR2, and change the port settings.
If you do not want to use Canon LPR2, proceed to step 2.
For instructions on how to install Canon LPR2 and set ports, see the Canon LPR2
User's Guide (PDF manual) on the UFR II Printer Kit/Super G3 FAX Board
CD-ROM.
If you want to use Canon LPR2, the port changes are complete.
IMPORTANT
If you want to use LPD, enter one of the following in [LPR Queue Name] in the [Add
Port] dialog box of Canon LPR2.
-LP
The machine prints according to its spool settings. Normally enter <LP> as a print
queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk, regardless of
its spool settings.
-DIRECT
The machine prints without spooling a print job on the hard disk, regardless of its
spool settings.
NOTE
If you are using Windows NT 4.0, you can set LPD by using the standard service of
your OS (Microsoft TCP/IP), without installing Canon LPR2. In this case, you
cannot set Raw. For instructions on how to install the Microsoft TCP/IP Printing
service, see steps 1 and 2 of "Installing a New Driver,'' on p. 3-31. For instructions
on how to change ports using the Microsoft TCP/IP Printing service, see steps 2 to
9.
2 On the [Start] menu, point to [Settings] ➞ click [Printers].