imageCLASS MF7280 Network Guide

Setting Up a Computer for Printing/Sending a Fax
3-30
3
Using a TCP/IP Network
10 If you want to use LPD, change the port configuration
information. If you want to use Raw, proceed to step 11.
❑ In the printer properties dialog box, click [Configure Port].
❑ Click [LPR] under [Protocol] ➞ enter a print queue in [Queue Name] under
[LPR Settings] ➞ click [OK].
You can specify a print queue in [Queue Name]. The following three print
queues are available:
• LP
The machine prints according to its spool settings. Normally, <LP> is
entered as a print queue.
• SPOOL
The machine prints only after spooling a print job on the hard disk,
regardless of its spool settings.
• DIRECT
The machine prints without spooling a print job on the hard disk, regardless
of its spool settings.
NOTE
If you are using Raw, this step is not required.
11 Click [OK].
The installation of the driver and the port settings is complete.
For Windows 2000