imageCLASS MF7280 Facsimile Guide

Placing Originals
1-42
1
Introduction to Fax Functions
If any dirt on the original scanning area is detected when the originals are
scanned using the feeder, the following screen appears. Even though streaks
may appear on the scanned image, you can continue to scan your documents by
pressing [Done].
It is recommended, however, that you open the feeder, clean the scanning area,
and then close the feeder. The following screen will not appear once the
scanning area is clean.
For instructions on cleaning the original scanning area, see Chapter 6, "Routine
Maintenance," in the Reference Guide.
IMPORTANT
• Do not add or remove originals while they are being scanned.
• When scanning is complete, remove the originals from the original output area to
avoid paper jams.
NOTE
• The scanned originals are output to the original output area in the order that they
are fed into the feeder.
• You can place different size originals together into the feeder if you set the Different
Size Originals mode. (See "Different Size Originals," on p. 2-17.)
Original Output Area