imageCLASS MF6540/MF6590/MF6595/MF6595CX Reference Guide

1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
6-16
Before Using the
Machine
Document and Paper
Copying
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only)
Printing and
Scanning
Network (MF6595cx/MF6595/
MF6590/MF6540 Only)
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
IP Address Range Settings
You can restrict the machine access from the computers on the
network by specifying the range of IP addresses allowed/ forbidden
to access the machine.
The default setting is <OFF>.
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3. Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4. Press [ ] or [ ] to select <TCP/IP SETTINGS>,
then press [OK].
5. Press [ ] or [ ] to select <SET IP ADD
RANGE>, then press [OK].
6. Press [ ] or [ ] to select <ON>, then press
[OK].
<OFF>: Disables IP address filter.
<ON>: Enables an IP address filter.
7. Press [ ] or [ ] to select <PERMIT/REJECT>,
then press [OK].
8. Press [ ] or [ ] to select <REJECT> or
<PERMIT>, then press [OK].
<REJECT>: Restricts the access to the machine (printing/PC faxing/
Remote UI) from the computers with certain IP addresses.
<PERMIT>: Permits the access to the machine (printing/PC faxing/
Remote UI) from the computers with certain IP addresses.
9. Press [ ] or [ ] to select <SET IP ADDRESS>,
then press [OK].
10. Press [ ] or [ ] to select from <IP ADDRESS
1> through <IP ADDRESS 4>, then press [OK].