Service manual

Chapter 5
5-3
5.2 Parts Replacement Procedure
5.2.1 Laser/Scanner Unit
5.2.1.1 Removing the Laser Scanner Unit
0011-5287
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
The laser scanner was-factory adjusted. Never disassemble it.
1) Detach the right cover, inner cover, delivery tray front cover, control
panel, and delivery tray.
2) Remove the laser shutter [1].
3) Disconnect the connector [2] and flexible cable [3].
4) Remove the four screws [4] using a stubby screwdriver, and then remove
the laser scanner unit [5].
F-5-2
MEMO:
When reinstalling the laser scanner unit, it is difficult to install the encircled
screw if your stubby screw driver is not magnetized. In this case, first install
the screw in the screw hole on the laser scanner unit, place the laser scanner
unit in place, and then tighten the screw tightly.
F-5-3
4) Remove the four screws [1] using a stubby screwdriver, and then remove
the laser scanner unit [2].
F-5-4
[3]
[4]
[4][1]
[2][5]
[2]
[1]
[1]
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com