Service manual

Chapter 4
4-11
4.4.10 Document Edge Sensor
4.4.10.1 Removing the Original Placement Sensor
0011-6037
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Detach the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
F-4-30
3) Release the claw to remove the original placement sensor [1], and then
disconnect the connector [2].
F-4-31
4.4.11 Registration Sensor
4.4.11.1 Removing the Registration Sensor
0011-6036
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the front cover and open/close cover.
2) Open the ADF, remove the three screws [1], and then detach the ADF left
lower cover [2].
F-4-32
3) Release the two claws [1], and then remove the grounding plate [2].
F-4-33
4) Disconnect the connector [1], release the hook, and then remove the
registration sensor [2].
F-4-34
4.4.12 Separation Sensor
4.4.12.1 Removing the Separated Paper Sensor
0011-5268
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Detach the rear cover.
2) Release the hook, remove the separated paper sensor [1], and then
disconnect the connector [2].
F-4-35
4.4.13 Pick-up Solenoid
4.4.13.1 Removing the Pickup Solenoid
0011-5240
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the feed frame unit.
2) Remove the three screws [1], and then remove the drive unit [2].
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com