Service manual

Chapter 4
4-10
Base MF6560PL / / LaserBase MF6580PL
1) Remove the pickup/feed roller unit.
2) Remove the screw [1], and then remove the roller bracket [2].
3) Remove the pickup roller [3].
F-4-24
4.4.7 Feed Roller
4.4.7.1 Removing the Feed Roller
0011-5236
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the pickup/feed roller unit.
2) Remove the screw [1], and then remove the roller bracket [2].
3) Remove the feed roller [3].
F-4-25
4.4.8 ADF Motor
4.4.8.1 Removing the ADF Motor
0011-5250
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the feed frame unit.
2) Remove the two screws [1], and then remove the drive unit [2].
F-4-26
3) Remove the two sensors [1] (by releasing the claws), two leaf springs [2]
(one screw each), two solenoids [3] (one screw each), one E-ring [4], and
three gears [5].
F-4-27
4) Remove the two gears [1] and three screws [2], and then remove the
bracket [3].
5) Remove the clamp from the motor frame. The remaining part is the ADF
motor unit [4].
F-4-28
Since the ADF motor unit was factory-adjusted, do not disassemble it fur-
ther.
After replacing the ADF motor unit, reinstall the parts removed in steps 3)
and 4).
4.4.9 Document Set Sensor
4.4.9.1 Removing the Document Set Sensor
0011-5254
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the rear cover.
2) Remove the connector [1], release the hook, and then remove the
document set sensor [2].
F-4-29
[1]
[3]
[2]
[1]
[3]
[2]
[1]
[2]
[1][1] [4][5] [5]
[2] [3][3]
[1]
[2]
[2] [4]
[3]
[2]
[1]