Service manual

Chapter 4
4-9
4.4.3 Feed Frame Unit
4.4.3.1 Removing the Feed Frame Unit
0011-5238
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Detach the front cover, rear cover, open/close cover, and pickup tray.
2) Disconnect the five connectors [1].
F-4-19
3) Remove the two front screws [1], two rear screws [2], and two grounding
screws [3] to remove the feed frame unit [4].
F-4-20
4.4.4 Drive Unit
4.4.4.1 Removing the Drive Unit
0011-5239
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the feed frame unit.
2) Remove the three screws [1], and then remove the drive unit [2].
F-4-21
When reinstalling the drive unit, make sure that the pickup solenoid lock
plate [1] is engaged with the gear.
F-4-22
4.4.5 Pick-up/Feed Roller Unit
4.4.5.1 Removing the Pickup/Feed Roller Unit
0011-5230
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the open/close cover.
2) Remove the shafts, and then remove the two shutters [1].
3) Press the support plate with your fingers to remove the shaft [2], and then
remove the pickup/feed roller unit [3].
F-4-23
When reinstalling the pickup/feed roller unit, care should be taken to the fol-
lowing:
1. The arms [4] must be behind the shutters [1].
2. The arms [4] must be behind the ribs [5].
4.4.6 Pick-up Roller
4.4.6.1 Removing the Pickup Roller
0011-5234
LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
[1] [1]
[1]
[1]
[3]
[4]
[2]
[1]
[2]
[1]
[1]
[3]
[4]
[4]
[2]
[5]
[5]
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com