imageCLASS MF6500 Series Advanced Guide

1
2
3
4
5
6
7
8
TOP
Back Previous Next
3-12
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
Network
Remote UI
System Monitor
Reports and Lists
Troubleshooting
Appendix
Checking the Current Network Settings
1. Press [Additional Functions].
2. Use [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3. Use [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4. Use [ ] or [ ] to select <VIEW IP
ADDRESS>, then press [OK].
5. Use [ ] or [ ] to select <IP ADDRESS>,
<SUBNET MASK>, or <GATEWAY ADDRESS>
for displaying the setting you want to check,
then press [OK].
6. Press [Stop] to return to standby mode.
■ Settings Using ARP/PING Commands
1. Start up the MS-DOS prompt or the
Command prompt.
2. Execute the following command to add a
static entry to the arp table.
arp -s <IP Address> <MAC Address>
<IP Address>: Specify the IP address you want to allocate to the
machine. The IP address consists of four numbers ranging from 0
to 255 with “.” as the breakpoint.
<MAC Address>: Specify the MAC address of the machine.
Every second digit is separated by “-”.
Input Example: arp -s 172.20.88.125 00-00-85-05-70-31
3. Execute the applicable command below to
set the IP address to the network board.
ping <IP Address> -l 479
<IP Address>: Specify the same address as the IP address you
specified in step 2 above.
Input Example: ping 172.20.88.125 -l 479
NOTE
– The character in “-l” is the letter “l.”
– The subnet mask address is set as <255.255.255.0> and the
gateway address is set as <0.0.0.0>.