imageCLASS MF6500 Series Advanced Guide

1
2
3
4
5
6
7
8
TOP
Back Previous Next
3-4
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
Network
Remote UI
System Monitor
Reports and Lists
Troubleshooting
Appendix
Using a TCP/IP Network
This chapter describes the settings and procedures
necessary to connect and use the machine with a TCP/IP
network.
1. Network Cable Connection (See “Installing/
Uninstalling Software,” in the Starter Guide.)
Connect the machine to your network using the network cables.
2. Interface Settings (See p. 3-5)
Specify the interface settings for communication between the
machine and computers on your network. To specify the settings,
use:
– Machine’s operation panel
– Web browser (Remote UI)
3. Communication Environment Setup (See
p. 3-7)
Set up a configuration for communication between the machine
and computers on your network. To specify the settings, use:
– Machine’s operation panel
– Web browser (Remote UI)
4. Preparation for Protocol Settings (See
p. 3-10)
Specify the machine’s IP address to make the machine and the
network computer can communicate before making protocol
settings. Any of the following can be used to specify the settings.
– Machine’s operation panel (Additional Functions menu)
– ARP/PING commands
– NetSpot Device Installer (Canon utility software included in the
User Software CD)
5. Protocol Settings (See p. 3-16)
Specify the machine’s protocol settings. Any of the following can
be used to specify the settings.
– Machine’s operation panel (Additional Functions menu)
– Web browser (Remote UI)
– NetSpot Device Installer (Canon utility software included in the
User Software CD)
6. Setting Up a Computer for Printing/Sending a
Fax (See p. 3-22)
Specify the settings for each computer you use for printing/
sending a fax.