imageCLASS MF6540/MF6590/MF6595/MF6595CX Reference Guide

1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
6-6
Before Using the
Machine
Document and Paper
Copying
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only)
Printing and
Scanning
Network (MF6595cx/MF6595/
MF6590/MF6540 Only)
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Interface Settings
Ethernet Driver
You can specify the communication method and Ethernet
connection type.
The default setting is <AUTO>.
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3. Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4. Press [ ] or [ ] to select <ETHERNET
DRIVER>, then press [OK].
5. Press [ ] or [ ] to select <AUTO DETECT>,
then press [OK].
■
6. Press [ ] or [ ] to select the desired
detection method, then press [OK].
<AUTO>: Automatically determines the communication mode (Half
duplex/Full duplex) and Ethernet type (10Base-T/100BaseTX). Skip to
step 11.
<MANUAL>: You have to manually specify the communication mode
and Ethernet type.
If you reconnect the network cable (for example, reconnect the cable
to a different Ethernet hub) with the power on, the Auto Detect
function will not work even if you set <AUTO DETECT> to <AUTO>.
(Connect the cable with the power off.)
7. If you have selected <MANUAL> in step 6, press
[
] or [ ] to select <DUPLEX>, then press
[OK].
8. Press [ ] or [ ] to select the desired
communication method, then press [OK].
<HALF DUPLEX>: Sends and receives alternately.
<FULL DUPLEX>: Sends and receives simultaneously.
9. Press [ ] or [ ] to select <ETHERNET TYPE>,
then press [OK].