imageCLASS MF6500 Series Advanced Guide

1
2
3
4
5
6
7
8
TOP
Back Previous Next
3-7
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
Network
Remote UI
System Monitor
Reports and Lists
Troubleshooting
Appendix
Communication Environment Setup
This section describes two additional protocols supported
for this machine: HTTP (HyperText Transfer Protocol) and
SNMP (Simple Network Management Protocol).
HTTP
HTTP helps communicate between your computer and the
machine via a web interface (e.g., Remote UI).
1. Press [Additional Functions].
2. Use [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3. Use [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4. Confirm that <TCP/IP SETTINGS> is
displayed, then press [OK].
5. Use [ ] or [ ] to select <USE HTTP>,
then press [OK].
6. Use [ ] or [ ] to select <ON>, then press
[OK].
7. Use the numeric keys to enter the HTTP port
number, then press [OK].
8. Press [Stop] to return to standby mode.
9. Restart the machine.
SNMP
SNMP helps monitor the state of the machine and collects
information on it. The following two items can be set:
<COMMUNITY NAME>:
Sets the SNMP community name. You can specify up to two
community names.
<SNMP WRITABLE>:
Enables the computers on the network to access the machine
and modify its settings if this item is activated. You can specify
this setting for each community separately.