Send Setting Guide
Sending an E-mail
Press the one-touch key you
registered.
If e-mail was delivered
successfully:
Go to Home.
Close the Guide.
If e-mail was not
delivered:
Go to the Remote UI
section.
Use the Remote UI to make sure
that the settings are correct.
Set the document.
Press the Sending Function key
repeatedly to select the color mode
(<E-MAIL: B&W> or <E-MAIL: COLOR>).
Conrm that the scanned image is sent to
the destination e-mail address.
Open your e-mail software to check if the e-mail was delivered.
Press [Start].
When you place the documents on the platen
glass, press or to select the document
size, then press [Start] for each document.
When scanning is complete, press [OK] to
start sending.
* The appearance of the operation panel may dier
depending on the model you use.
This section explains how to scan a document and send the scanned image
via e-mail.
03
Setting Up
About Buttons
Outline
Sending an e-mail