imageCLASS MF4690 Reference Guide

1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
4-17
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
3. Press [ ] or [ ] to select <GROUP DIAL>,
then press [OK].
4. Press [ ] or [ ] to select a group to edit, then
press [OK].
To select a group stored under the coded dial code, press [Coded
Dial], then enter the three-digit code using the numeric keys.
5. Press [ ] or [ ] to select <SELECT ADD/TEL
NO>, then press [OK].
6. Select the destination you want to add to the
group, then press [OK].
For details on specifying a destination from Address Book, see
“Registering Group Addresses,” on p. 4-15.
7. Press [Stop/Reset] to return to the standby
mode.
Deleting Destination from Group
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <ADDRESS BOOK
SET.>, then press [OK].
3. Press [ ] or [ ] to select <GROUP DIAL>,
then press [OK].
4. Press [ ] or [ ] to select a group to edit, then
press [OK].
To select a group stored under the coded dial code, press [Coded
Dial], then enter the three-digit code using the numeric keys.
5. Press [ ] or [ ] to select <SELECT ADD/TEL
NO>, then press [OK].
6. Press [ ] or [ ] to display the destination
you want to delete from the group, then press
[Clear].
Repeat this step if you want to delete another destination.
7. Press [OK].
8. Press [Stop/Reset] to return to the standby
mode.