Specifications

1
2
3
4
5
6
TOP
Back Previous Next
5-13
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
System Monitor
Reports and Lists
Troubleshooting
Appendix
Q Is the toner cartridge out of toner?
A Replace the toner cartridge. (See Chapter 10,
“Maintenance,” in the Basic Guide.)
Q Is the correct type of paper loaded in the
machine?
A Make sure you load paper that meets the
requirements for use. (See Chapter 3, “Print
Media,” in the Basic Guide.)
Received faxes print blotched or unevenly.
Q Are the telephone lines in poor condition, or do
you have a bad connection?
A Error Correction Mode (ECM) should eliminate
such problems. However, if the telephone lines are
in poor condition, you may have to try again.
Q Is the sender’s machine functioning properly?
A Ask the sender to check that the scanning
components of the machine are clean.
Q Is the toner low or unevenly distributed?
A Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge.
(See Chapter 10, “Maintenance,” in the Basic
Guide.)
Receiving of documents is too slow.
Q Is the resolution set to <FINE> or <SUPER
FINE>?
A Setting the resolution to <STANDARD> reduces
the receiving time. However, any fine text in the
document will also be harder to read.
You cannot get documents from information services.
Q Is your machine connected to a rotary pulse
telephone line?
A According to the instructions of information service,
press [Tone] to carrying out the tone pulse
temporarily.