imageCLASS MF4150 Advanced Guide

1
2
3
4
5
6
TOP
Back Previous Next
4-4
Table of Contents
Index
Advanced Fax
Features
Advanced Copy
Features
System Monitor
Reports and Lists
Troubleshooting
Appendix
● RESULT: Result of transaction
– OK: Transmission successful
– NG: Transmission failed
– STOP: Transmission manually canceled before completion
– MEM.FULL: Memory became full during transmission
– NO ANSWER: Call not answered
– PAPER JAM: ADF jam occurs during Manual TX
● Error code: For descriptions of error codes, see Chapter
11, “Troubleshooting,” in the Basic Guide.
NOTE
ERROR TX REPORT or MULTI TX REPORT is printed out depending
on the transmission result.
■ RX REPORT
1. Press [Additional Functions].
2. Use [ ] or [ ] to select <REPORT
SETTINGS>, then press [OK].
3. Use [ ] or [ ] to select <SETTINGS>,
then press [OK].
4. Use [ ] or [ ] to select <RX REPORT>,
then press [OK].
5. Use [ ] or [ ] to select the setting you
want, then press [OK].
<OUTPUT NO>: Does not print a report.
<OUTPUT YES>: Prints a report every time you receive a
document.
<PRINT ERROR ONLY>: Prints a report only when a reception
error occurs.
6. Press [Stop/Reset] to return to the standby
mode.
Report Items
The following items are displayed in the Reception Result
Report:
● JOB NO.: Job number
● TYPE: Type of reception
– RX: Memory or print reception
● NO.: Sequence number
● DESTINATION TEL/ID: Number of the sending machine
(displayed only if registered in their machine)
● DATE: Date of transaction
● TIME: Time of transaction
● PAGE: Number of pages received
● TIME USE: Amount of time taken for a transaction
● MODE: Mode of transaction (G3 or ECM)