imageCLASS MF3200 Series Software Guide

1
2
3
4
5
6
TOP
Back Previous Next
5-12
Table of Contents
Index
Introduction
Printing
Scanning a
Document
PC Faxing
Troubleshooting
Appendix
White lines appear on one edge of the image you scan.
Q Is the document placed on the platen glass
correctly?
A Place the document at approximately 1/8" (3 mm)
from the front edge of the platen glass.
Cannot scan highlighted marks.
Q Is [Color Correction] set to [Color Matching] ?
A In [Advanced Mode] in ScanGear MF, set [Color
Correction] to [Color Matching]. (See “[Color
Settings] Tab,” on p. 3-36.)
Scanned image is displayed at a larger (smaller) size on the
computer screen.
Q Is the resolution setting correct?
A Do one of the following:
– Enlarge or reduce the image display in the
application. If you open the image in Paint or
Imaging, it may display at a large size and you
will not be able to reduce it.
– Change the resolution and scan again.
The image will be large if the resolution is high. It
will be small if the resolution is low. (See
“Determining Resolution,” on p. 3-38.)