Network Guide for imageCLASS 2300N

NetWare Network Setup Procedures
3-2
Using a NetWare Network (Windows)
3
NetWare Network Setup Procedures
To use a NetWare network, it is necessary to perform the following procedures.
IMPORTANT
• It is recommended that the network manager perform steps 1, 2, and 3 above.
• To configure settings with software other than NetSpot Console or NetSpot Device
Installer, TCP/IP protocol must be supported by your network environment.
• When printing in a NetWare network, disable the banner page.
1
Network Cable Connection (See Chapter 1, "Before You Start Using This
Machine," in the PCL Printer Guide.)
Connect the network cables in accordance with the PCL Printer Guide.
2
NetWare Print Service Settings (See "NetWare Print Service Settings," on p. 3-
3.)
Specify the NetWare print service settings. To specify the settings, use:
• NetSpot Device Installer (Canon software included on the Network User Software CD-ROM)
• NetSpot Console (via a web browser) (Canon software included on the Network User Software CD-ROM)
• NWADMIN or PCONSOLE (Novell software provided with NetWare)
3
Protocol Settings (See "Protocol Settings," on p. 3-8.)
Specify the protocol settings. To specify the settings, use:
• NetSpot Device Installer (Canon software included on the Network User Software CD-ROM)
• NetSpot Console (via a web browser) (Canon software included on the Network User Software CD-ROM)
• A web browser (Remote UI)
• An FTP client
4
Computer Settings for Printing (See "Setting Up a Computer for Printing," on
p. 3-10.)
Specify the settings for each computer you use for printing.