Network Guide for imageCLASS 2300N

Setting Up a Computer for Printing
2-25
Using a TCP/IP Network (Windows/UNIX)
2
5 Specify the Port settings.
❑ Click [Add Port] to open the [Add Port] dialog box.
❑ Select [Other].
❑ Under [Click the type of port you want to add], select [CANON LPR Port] ➞
click [OK].
The [Add LPR Port] dialog box opens.
❑ Enter the printer host name or IP address in [Host Name] or [IP Address].
❑ Enter "LP" in [Printer Name] ➞ click [OK].
IMPORTANT
Before setting the port, check that the machine is connected to the network, and
that the machine is turned ON.
NOTE
You can specify a print queue in [Printer Name]. The following three print queues
are available (be sure to use only capital letters to enter a print queue):
- LP: The machine prints according to its spool settings. Normally enter "LP" as a
print queue.
- SPOOL: The machine prints only after spooling a print job on the hard disk
regardless of its spool settings.
- DIRECT: The machine prints without spooling a print job on the hard disk
regardless of its spool settings.