Basic Guide for imageCLASS 2300

Copy Operations
4-8
Copying - Basic Operations
4
● If you want to cancel a copy job in the standby mode:
❑ Press [Stop].
The display for selecting a copy job to cancel appears.
❑ Press [F2] (▼) or [F3] (▲) to select the copy job you want to cancel ➞ press
[F4] (CANCEL).
The selected job is canceled.
NOTE
After pressing (Stop), several copies may continue to print out.
You can also cancel a copy job from the System Monitor screen. (See Chapter 1,
"Introduction to Copying," in the Copying Guide.)
● If you want to interrupt a copy job:
❑ To interrupt a copy job when you need to make priority copies, press [Interrupt].
For instructions on interrupting a copy job, see Chapter 1, "Introduction to
Copying," in the Copying Guide.
The message <ABLE TO PERFORM INTERRUPT JOB> appears on the LCD
display.
● If you want to reserve a copy job and scan an original while the
machine is printing:
❑
Place your original ➞ press [Start].
For instructions on reserving a copy job, see Chapter 1, "Introduction to
Copying," in the Copying Guide.
8 When scanning is complete, remove your original.
9 If you have set Department ID Management, press [ID].
For instructions on using Department ID Management, see Chapter 5, "System
Manager Settings," in the Reference Guide.
F2
F3
F4
Interrupt
Start
Stop
ID