User`s guide

Self-diagnostic Display

9-16

Troubleshooting

# 0408

Cause 1 The transfer of data has failed because the USB memory media device was

pulled out during the transfer.

Remedy Check that the USB memory media device is properly inserted, and then try the

transfer again.

Cause 2 An error occurred while data, such as image data, was being transferred to the

USB memory media device.

Remedy Check the status of the USB memory media device, or make sure that the

device is formatted with a file system supported by the machine (FAT16 or

FAT32), and then try again.

# 0703

Cause The memory for image data is full when sending color documents.

Remedy 1 Wait for a few moments and try again after other send jobs are complete.

Remedy 2 Delete documents stored in memory. If the machine still does not operate

normally, turn the main power OFF and then back ON.

# 0705

Cause The send operation was interrupted because the size of the image data is larger

than that specified in <Maximum TX Data Size> in E-mail/I-Fax Settings.

Remedy 1 Change the setting for <Maximum TX Data Size> in E-mail/I-Fax Settings. (See

Chapter 4, “Setting the Send Function,” in the System Settings Guide.)

Remedy 2 Select a lower resolution. (See “Specifying the Color Mode and Resolution,” on

p. 3-2.)

Remedy 3 If you are using I-fax, decrease the number of pages containing images that you

are sending each time, so that you do not exceed the data size limit specified in

<Maximum TX Data Size>.

Remedy 4 Set Divide into Pages to ‘On’ on the File Format screen. (See “Specifying the

File Format,” on p. 3-20.)

# 0751

Cause 1 The file server is not functioning.

Remedy Check that the file server is operating properly.