User`s guide

Stamping Originals Which Have Already Been Scanned
3-24
Specifying the Scan Settings
3
4 Press (Start) to start scanning your originals.
To cancel scanning, press [Cancel] or (Stop).
The scanned data is sent to the specified destination when scanning is complete.
A stamp mark ( ) appears on the original output.
NOTE
• If the stamp mark is not clear, see Chapter 5, “Routine Maintenance,” in the Reference
Guide.
• The specified settings return to their defaults after documents are sent. If you want to
keep the settings as the default, see “Registering Frequently Used Scan Settings as
Default (Standard Send Settings),” on p. 7-5.
2 Press [Send Settings].
3 Press [Stamp] ➞ [Done].
NOTE
To cancel the Stamp mode, press
[Stamp] again.