User`s guide

Stamping Originals Which Have Already Been Scanned

3-23

Specifying the Scan Settings

Stamping Originals Which Have Already Been Scanned

The feeder directly applies a stamp (about 3 mm in diameter) on the front side of

originals after scanning them, so that you can distinguish scanned originals from

those that have not been scanned.

IMPORTANT

• The Stamp mode is available only when the following options are attached to the

machine:

- Stamp Unit-B1

- Feeder* (DADF-AA1 for the imageRUNNER 2545/2535 or DADF-AB1 for the

imageRUNNER 2530/2525/2520)

* Standard-equipped for the imageRUNNER 2545i/2535i/2530i/2525i/2520i.

• The Stamp mode cannot be used with the following modes:

- Document Size (except for [Auto]) (See “Specifying the Document Size,” on p. 3-6.)

- Different Size Originals (See “Scanning Different Size Originals Together (Different

Size Originals),” on p. 3-15.)

- Direct Sending (See “Direct Sending,” on p. 2-28.)

- Manual Sending (See “Manual Sending,” on p. 2-31.)

Press (SEND) ➞ place your originals into the feeder ➞

specify the destination.

NOTE

• For instructions on how to place your originals, see Chapter 2, “Basic Operations,” in

the Reference Guide.

• For instructions on how to specify the destination, see “Basic Sending Methods,” on

p. 2-2, or Chapter 4, “Specifying Destinations Easily and Quickly.”