User`s guide

Specifying Common Settings
3-29
Configuring the Machine’s Basic Settings
3
Setting the Limited Functions Mode
Using the finishing modes may sometimes result in problems due to their functional
complexity. You can manually limit the use of the finishing modes to prevent the
recurrence of the problems, if they occur.
IMPORTANT
The Limited Functions Mode is available only when the optional Inner Finisher-B1 is
attached to the machine.
NOTE
The default setting is ‘Off’.
1 Press (Additional Functions) ➞ [Common Settings].
For help, see steps 1 and 2 in “Initial Function at Power ON,” on p. 3-2.
4 Restart the machine.
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
2 Press [ ] or [ ] until
[Limited Functions Mode]
appears ➞ press
[Limited Functions Mode].
3 Press [On] or [Off] to enable or
disable the mode ➞ press [OK].
The selected mode is set.