User`s guide

Specifying Common Settings
3-22
Configuring the Machine’s Basic Settings
3
3 Specify the desired nonstandard paper size:
IMPORTANT
Make sure that the paper size setting is correct. If the paper size loaded on the stack
bypass and the paper size setting do not match, a paper jam may occur.
NOTE
• If you make a mistake when entering numbers, press [C] (Clear) ➞ enter the correct
numbers.
• When entering numbers in millimeters, you can also use - (numeric keys) and
(Clear) on the control panel.
• To enter values in inches, press [Inch]. (See “Entering Values in Inches,” on p. 3-7.)
• When entering the length in inches, an underbar (_) must be entered between integer
and fraction.
4 Press (Reset) to return to the top screen.
Selecting the Paper Feed Method
You can set whether the printing speed is the priority for your job, or whether to print
on a specific side of the paper. This setting is useful when you want to make one- or
two-sided prints on preprinted paper (paper which has logos or patterns already
printed on it) without turning over the paper loaded in a paper source.
NOTE
The default settings are ‘Speed’ for all paper sources.
❑ Press [Size 1] or [Size 2].
You can register two kinds of
nonstandard paper sizes.
❑ Press [X] ➞ enter the length along the
horizontal axis of the paper using [-] or
[+].
The horizontal length can be set
between 148 mm and 432 mm.
❑ Press [Y] ➞ enter the length along the
vertical axis of the paper using [-] or [+].
The vertical length can be set between
99 mm and 297 mm.
❑ Press [OK].
Repeat this step to register or edit another
size of nonstandard paper.