User`s guide

Specifying Common Settings

3-19

Configuring the Machine’s Basic Settings

IMPORTANT

Make sure that the paper size setting is correct. If the paper size loaded on the stack

bypass and the paper size setting do not match, a paper jam may occur.

NOTE

• If you make a mistake when entering numbers, press [C] (Clear) ➞ enter the

correct numbers.

• When entering numbers in millimeters, you can also use - (numeric keys)

and (Clear) on the control panel.

• To enter values in inches, press [Inch]. (See “Entering Values in Inches,” on

p. 3-7.)

• When entering the length in inches, an underbar (_) must be entered between

integer and fraction.

• You can press [Size 1] or [Size 2] to specify the paper size if the values for the

horizontal and vertical axes are registered beforehand. (See “Registering

Nonstandard Paper Sizes,” on p. 3-21.)

❑ Press [X] ➞ enter the length along the

horizontal axis of the paper using the

numeric keys.

The horizontal length can be set

between 148 mm and 432 mm.

❑ Press [Y] ➞ enter the length along the

vertical axis of the paper using the

numeric keys.

The vertical length can be set between

99 mm and 297 mm.

❑ Press [OK].

❑ Press [Next].