User`s guide

Specifying Common Settings
3-15
Configuring the Machine’s Basic Settings
3
IMPORTANT
• The Tray Designation setting is available only when the optional Inner Finisher-B1 with
the Inner Finisher Additional Tray-B1 or Inner 2 Way Tray-G1 is attached to the
machine.
• The Inner 2 Way Tray-G1 must be enabled prior to use. (See Chapter 7, “Other
System Settings,” in the System Settings Guide.)
• If the optional Inner Finisher Additional Tray-B1 or Inner 2 Way Tray-G1 is attached,
you must enable the functions for Tray B so that the machine can deliver the prints to
it.
NOTE
The default settings are as follows:
- Tray A: ‘On’ for all job types (All kinds of prints can be delivered to Tray A.)
- Tray B: ‘Off’ for all job types (Tray B is disabled.)
1 Press (Additional Functions) ➞ [Common Settings].
For help, see steps 1 and 2 in “Initial Function at Power ON,” on p. 3-2.
2 Press [ ] or [ ] until
[Tray Designation] appears ➞
press [Tray Designation].