User`s guide

Loading Paper in the Stack Bypass

2-27

Basic Operations

● If you want to select a nonstandard paper size:

IMPORTANT

Make sure that the paper size setting is correct. If the paper size loaded on the

stack bypass and the paper size setting do not match, a paper jam may occur.

NOTE

• If you make a mistake when entering values, press [C] (Clear) ➞ enter the

correct values.

• When entering values in millimeters, you can also use - (numeric keys)

and (Clear) on the control panel.

• To enter values in inches, the Inch Entry setting must be enabled. (See “Entering

Values in Inches,” on p. 3-7.)

• When entering the length in inches, an underbar (_) must be entered between

integer and fraction.

• You can store up to two sets of frequently used sizes. Press [Store/Edit] ➞ [Size

1] or [Size 2] ➞ enter the value for <X> and <Y> ➞ press [OK].

• To recall the stored size, press [Size 1] or [Size 2] ➞ press [OK] and proceed to

the next step to specify the paper type.

❑ Press [Irreg. Size].

❑ Press [X] ➞ enter the length along the

horizontal axis of the paper using the

numeric keys.

The horizontal length can be set

between 148 mm and 432 mm.

❑ Press [Y] ➞ enter the length along the

vertical axis of the paper using the

numeric keys.

The vertical length can be set between

99 mm and 297 mm.

❑ Press [OK].