User`s guide

Self-diagnostic Display
6-18
Troubleshooting
6
# 0404
Cause The job failed because the write protect switch of the USB memory media
device was on.
Remedy Turn off the write protect switch of the USB memory media device.
# 0406
Cause 1 The job failed because the USB memory media device was pulled out during
transmission.
Remedy Check that the USB memory media device is properly inserted, and then try
sending again.
Cause 2 An error occurred while data, such as image data, was being transferred to the
USB memory media device. (The connected device may be formatted with a file
system that is not supported by the machine.)
Remedy Check the status of the USB memory media device, or make sure that the
device is formatted with a file system supported by the machine (FAT16 or
FAT32), and then try again.
# 0407
Cause 1 The length of the full path to the specified file (or folder) exceeded the
supported limit.
Remedy The full path must not be longer than 120 characters. Change or shorten the file
name.
Cause 2 The transmission to the USB memory media device was not properly performed
because the length of the full path including the root and file name exceeded the
limit.
Remedy 1 The full path must not be longer than 120 characters. Change or shorten the file
name.
Remedy 2 Change the folder to which the data is saved.
# 0701
Cause The specified Department ID does not exist, or the password has changed.
Remedy Enter the correct Department ID and password using - (numeric keys) on
the control panel, and try again. (See “Entering the Department ID and
Password,” on p. 2-9.)