Service manual

1
-
3
Error messages are displayed on the monitor of the connected computer.
Start the status monitor on the host computer in order to display the error messages.
Cyclical flash (Error Code)
Error description Action Assembly/disassembly precautions Adjustment
2
(5100)
CR error Replace code strip/carriage
unit/logic board
- Be careful of electrostatic damage - Do not loosen or remove red screws - There must be no grease on code strip
- Apply grease (see 3.2.3) - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
3
(6000)
LF error Replace code wheel/LF encoder
unit/logic board
- Be careful of electrostatic damage - Do not loosen or remove red screws - There must be no grease on code strip
- Apply grease (see 3.2.3) - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
4
(5C00)
Recovery system error Replace purge unit/logic board - Be careful of ink stains
- Be careful of electrostatic damage
- Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
6
(5400)
Internal temperature error *
1
Replace logic board
- Be careful of electrostatic damage
- Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
7
(5B00)
Waste ink full error Replace waste ink absorber/logic
board
- Be careful of ink stains - Be careful of electrostatic damage - Do not loosen or remove red screws
- Clear EEPROM (see 3.2.2) - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
8
(5200)
Head overheating error Replace head/logic board - Be careful of ink stains
- Be careful of electrostatic damage
- Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
9
(6800)
EEPROM error Replace logic board - Be careful of electrostatic damage - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
10
(6100)
ROM error *
2
Replace logic board - Be careful of electrostatic damage - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
11
(6300)
RAM error *
2
Replace logic board - Be careful of electrostatic damage - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
13
Other hardware error *
2
Replace head/logic board - Be careful of ink stains
- Be careful of electrostatic damage
- Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
LED ON*
1
(6800)
RAM error Replace logic board - Be careful of electrostatic damage - Set waste ink counter (see 3.2.1)*
2
- Set destination (see 3.3.2)
*
1
: i550/i850 only *
2
: i950 only