Service manual

COPYRIGHT © 1999 CANON INC. CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 EXTERNAL/AUXILIARY MECHANISM
9-25
C. DC controller PCB
1) Remove the printer unit from the
main body (see page 9-19 for further
information).
2) Stand the printer unit in the same
way as depicted in Figure 9-516.
3) Remove all connectors which are
attached to the DC controller PCB.
4) Remove the 4 installation screws [1].
5) Slide the DC controller PCB together
with the support plate upwards. Then,
pull it out towards the front.
Figure 9-516
Figure 9-517
■ When standing the printer unit on a
desk or other furniture, please be
careful not to scratch the surface of
the furniture.
■ Also, before performing this step,
please spread out newspapers, etc.
to ensure the right side of the print-
er unit’s external cover is not
scratched.
■ Do not perform this operation on an
unstable surface. Stand the printer
unit on a horizontal surface, and
make sure that it cannot topple
over. Make sure to remove the car-
tridge prior to standing the printer
unit up.
Caution:
[1]
Slide
[1]
Download Free Service Manual at http://printer1.blogspot.com