Service manual

COPYRIGHT © 1999 CANON INC. CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 EXTERNAL/AUXILIARY MECHANISM
9-20
5) Remove the 2 installation screws [2]
on the fixing assembly, and remove
the grounding cable [3].
6) Remove the 5 connectors [4], which
are attached to the DC controller
PCB.
7) Remove the stop ring, and remove
the cord guide [5].
8) Remove the installation screw [6],
and remove the cartridge drive
release plate [7].
9) While gripping the release lever [8],
slowly pull out the printer unit.
10)Place your hand in the cassette
insertion inlet, and while pushing on
the upper portion of the release
catch, slowly pull out the printer unit.
Once the unit has come out far
enough, place your hands on the
front part and the rear side, and con-
tinue to remove the printer unit while
supporting it.
Figure 9-507
Figure 9-508
If the printer unit is pulled out too
quickly, there is a chance that it may
fall out, so please be sure to pull it out
slowly.
Caution:
[2]
[3]
[5]
[4]
[6] [7]
[8]
Catch
Lower side of the main unit
(Upper portion of the recording
paper insertion inlet)
Push
Download Free Service Manual at http://printer1.blogspot.com