Service manual

COPYRIGHT © 1999 CANON INC. CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP/FEEDING SYSTEM
7-27
6) Remove the E-ring [9], then remove
the vertical path clutch [10] and the
registration roller clutch [11] (is it not
necessary to remove the clutch con-
nectors).
7) Remove the connector [12] and relay
connector [13] from the DC controller
PCB (printer unit rear side). Remove
the disconnected cable from the cord
guide.
8) Remove the installation screw [14]
and remove the earth plate spring
[15].
9) Remove the installation screw [16],
and then remove the printer unit sup-
port roller [17].
10) Remove the tension spring from the
rear side printer unit pressure lever
[18], then slightly slide the pressure
lever together with the axis.
Figure 7-707
Figure 7-708
Figure 7-709
[11] [9]
[10]
[9]
[12]
[13]
[18]
[16]
[17]
[14]
[15]
Download Free Service Manual at http://printer1.blogspot.com