Specifications

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON DADF-J1 REV.0 MAR.2001
CHAPTER 5 TROUBLESHOOTING
5-20
If the Value Is Not As Indicated
If the value is not as indicated, adjust the
position of the manual feed tray.
1) Loosen the manual feed tray fixing
screw, and adjust the position of the
manual feed tray.
2) At the end of adjustment, tighten the
manual feed tray fixing screw.
3) Set the DIP switch (SW1) on the ADF
controller PCB back to its initial setting,
and mount the ADF controller cover.
If C>3.1 mm for A4 or 11.9 mm for LTR, shift
the manual feed tray toward the rear.
If C<3.1 mm for A4 or 11.9 mm for LTR, shift
the manual feed tray toward the front.
F05-101-43
1.1.5 Original Stop Position Adjust-
ment
Original stop position adjustment is made
for the following two:
[1] Pickup from the original tray
[2] Pickup from the manual feed tray
a. Original Tray Pickup
1) Remove the screw, and detach the ADF
controller cover.
2) Set the DIP switch (SW10) on the ADF
controller PCB as indicated.
F05-101-44
F05-101-45
Screw
Manual feed tray
ADF controller cover
Screw