Specifications

CHAPTER 2 OPERATION AND TIMING
2-10
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
D. Reading/SENT Stamp (DADF-A1 only)
The stamping mechanism is part of the feeder (DADF-A1), and may be READ stamp or SENT
stamp.
A single stamp is used for both, and is designed to put a pink dot 3 mm in diameter.
The stamping mechanism is enabled by operating "transmission settings" of "additional
functions." It functions as follows:
It does not operate in copier, test shot, or copyboard mode.
It prohibits advance feed when picking up originals.
It puts a stamp on both originals in 2-on-1 read mode.
It puts a stamp on the face only when reading a two-sided original.
It starts direct transmission mode when combined with rapid transmission mode, and uses the
SENT stamp.
1. SENT Stamp
A stamp is put in response to the receipt acknowledge signal from the receiving machine.
It is available only for direct transmission.
2. READ Stamp
A stamp is put when the image read by the scanner has been stored in the image memory.
The location of the stamp when the DADF is used will be as follows:
Figure 2-203 Stamp Location (DADF-A1)
Original
50 mm
(approx.)
23 mm (approx.)
Center of original
Feeding direction