Specifications

CHAPTER 5 ERROR CODE
5-22
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
##780 (transmission) excess procedure signal re-transmission after transmission of EOR-
EOM (acknowledge signal not received)
Cause Remedy
• The condition of the line is poor, and the other
device cannot receive EOR-EOM.
• The condition of the line is poor, and signals
cannot be received.
• Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other
device may receive EOR-EOM properly.
• Request the other party to raise the transmission
level of the other device to ensure correct recep-
tion of EOR-EOM.
• Try re-transmission.
##782 (transmission) DCN reception after transmission of EOR-EOM
Cause Remedy
• The line condition is poor, and the other device
cannot receive EOR-EOM correctly.
• The Stop button is pressed during communica-
tion.
• Raise the transmission level of the modem using
parameter 07 of #2MENU to ensure proper recep-
tion of EOP-EOM by the other device.
• Try re-transmission.
##783 (transmission) excess procedure signal re-transmission or T5 time-over (60 sec) after
transmission of PPS-EOM
Cause Remedy
• The page buffer of the other device is full or is
in use and, although RNR has been received
after transmission of PPS-EOM, an acknowledge
signal cannot be received after transmission of
RR.
1. Turn the setting of 'CUSTOM FAX SETTINGS >
TX SETTINGS > ECM TX' to 'OFF'.
2. Lower the setting of 'CUSTOM FAX SETTINGS >
SYSTEM SETTINGS > TX START SPEED'.