Specifications

CHAPTER 5 ERROR CODE
5-20
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
##765 (transmission) excess procedure signal re-transmission after transmission of PPS-EOP
(acknowledge signal not received)
Cause Remedy
• The condition of the line is poor, and the other
device cannot receive PPS-EOP properly.
• The condition of the line is poor, and signals
cannot be received properly.
1. Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other
device may receive PPS-EOP properly.
2. Adjust the NL equalizer using parameter 05 of
#2MENU so that the other device may receive
PPS-EOP properly.
3. Attach an echo protect tone to the V.29 modem
signal using bit 1 of SW03 of #1 SSSW.
• Request the other party to raise the transmission
level of the other device to ensure correct recep-
tion signals.
##767 (transmission) DCN received after transmission of PPS-EOP
Cause Remedy
• The condition of the line is poor, and the other
device cannot receive PPS-EOP properly.
• The Stop key was pressed during communication.
• Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other
device may receive PPS-EOP properly.
• Try re-transmission.
##768 (transmission) excess procedure signal re-transmission or T5 time-over (60 sec) after
transmission of PPS-EOP
Cause Remedy
• The page buffer of the other device is full or is
in use and, although RNR has been received after
transmission of PPS-EOP, an acknowledge signal
cannot be received after transmission of RR.
1. Turn the setting of 'CUSTOM FAX SETTINGS >
TX SETTINGS > ECM TX' to 'OFF'.
2. Lower the setting of 'CUSTOM FAX SETTINGS >
SYSTEM SETTINGS > TX START SPEED'.