Specifications

COPYRIGHT © 1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
5-19
CHAPTER 5 ERROR CODE
##762 (transmission) DCN received after transmission of PPS-EOM
Cause Remedy
• The condition of the line is poor, and the other
device cannot receive PPS-EOM properly.
• The Stop key was pressed during communication.
• Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other party
may receive PPS-EOM properly.
• Try re-transmission.
##763 (transmission) excess procedure signal re-transmission or T5 time-over (60 sec) after
transmission of PPS-EOM
Cause Remedy
• The page buffer of the other device is full or is
in use and, although RNR has been received after
transmission of PPS-EOM, an acknowledge
signal cannot be received after transmission of
RR.
1. Turn the setting of 'CUSTOM FAX SETTINGS >
TX SETTINGS > ECM TX' to 'OFF'.
2. Lower the setting of 'CUSTOM FAX SETTINGS >
SYSTEM SETTINGS > TX START SPEED'.
##764 (transmission) excess procedure signal re-transmission after transmission of PPS-EOM
Cause Remedy
• The condition of the line is poor and, although
PPR has been received four times after transmis-
sion of PPS-EOM and CTC has been transmitted,
the other device cannot receive the signals
properly.
• The condition of the line is poor and, although
CTC has been transmitted after receiving PPR
four times and transmission of PPS-EOM has
been transmitted, an acknowledge signal cannot
be received properly.
• Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other
devicemay receive CTC properly.
• Request the other party to raise the transmission
level of the other device to ensure correct recep-
tion of signals.