Specifications

ManualsBrandsCanon ManualsAll in One PrinterFY8-13FW-000DADF-A1

191

192

193

194

195

196

197

198

199

200

CHAPTER 5 ERROR CODE

5-18

1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)

##758 (transmission) excess procedure signal re-transmission or T5 time-over (60 sec) after

transmission of PPS-MPS

Cause Remedy

• The page buffer of the other device is full or is

in use and, although RNR has been received

after transmission of PPS-MPS, an acknowledge

signal cannot be received properly after transmis-

sion of RR.

1. Turn the setting of 'CUSTOM FAX SETTINGS >

TX SETTINGS > ECM TX' to 'OFF'.

2. Lower the setting of 'CUSTOM FAX SETTINGS >

SYSTEM SETTINGS > TX START SPEED'.

##759 (transmission) excess procedure signal re-transmission after transmission of PPS-MPS

Cause Remedy

• The condition of the line is poor and, Although

PPR has been received four times after transmis-

sion of PPS-MPS and CTC has been transmitted,

the other party cannot receive the signal properly.

• The condition of the line is poor and, although

PPR has been received four times after transmis-

sion of PPS-MPS, an acknowledge signal cannot

be received after transmission of CTC.

• Raise the transmission level of the modem using

parameter 07 of #2 MENU so that the other

device may receive CTC properly.

• Ask the transmission level of the other device to

ensure correct reception of signals.

##760 (transmission) excess procedure signal re-transmission after transmission of PPS-

EOM (acknowledge signal not received)

Cause Remedy

• The condition of the line is poor, and the other

device cannot receive PPS-EOM properly.

• The condition of the line is poor, and signals

cannot be received properly.

1. Raise the transmission level of the modem using

parameter 07 of #2 MENU so that the other

device may receive PPS-EOM properly.

2. Adjust the NL equalizer using parameter 05 of

#2 MENU so that the other device may receive

PPS-EOM properly.

3. Attach an echo protect tone to the V.29 modem

signal using bit 1 of SW03 of #1 SSSW.

• Request the other party to raise the transmission

level of the other device.