Specifications

CHAPTER 5 ERROR CODE

5-14

1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)

##290 (transmission) non-PIN, -PIN, -MCF, -RTP, -RTN signal received after transmission of

MPS during transmission

Cause Remedy

• An error occurred in the procedure signal. • Make a recording of the communication proce-

dure sound on DAT, and have it analyzed.

##671 (reception) line released by T1 time-out (procedure fails to move to 2 after detection of

CM signal of caller during V.8

Cause Remedy

• The line of the caller broke in phase 1, or signals

of the caller cannot be detected.

• Prohibit the V.8/V.34 procedure of the caller

using bit 1 of SW28 of #1 SSSW.

• Adjust the transmission level to between 0 and

-15 dBm.

##672 (transmission) line released by T1 time-out (procedure fails to move to phase 3 from

phase 2 during V.34 transmission)

Cause Remedy

• The line of the receiving device broke in phase

2, and signals of the receiving device cannot be

received.

• Prohibit V.8/V.34 procedure of the caller using

bit 0 of SW28 of #1 SSSW.

• Adjust the transmission level to between 0 and

-15 dBm.

##673 (reception) line released by T1 time-out (procedure fails to move to phase 3 from

phase 2 in V.34 reception)

Cause Remedy

• The line of the transmitting device broke in

phase 2, or signals of the transmitting device

cannot be detected.

• Prohibit V.8/V.34 procedure using bit 1 of SW28

of #1 SSSW.

• Adjust the transmission level to between 0 and

15 dBm.