Specifications
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
5-11
CHAPTER 5 ERROR CODE
##220 (transmission/reception) system error (main program out of control)
Cause Remedy
• Noise caused the CPU to operate. • Turn off and then on the power.
##224 (transmission/reception) error in procedure signal in G3 mode
Cause Remedy
• An error occurred in the procedure signal. • Make a recording of the communication proce-
dure sound on DAT, and have it analyzed.
##232 (transmission) malfunction of fax PCB
Cause Remedy
• The operation of the UPI used to control
ENCODE failed to end normally.
• Replace the fax PCB.
##237 (reception) fax PC malfunction
Cause Remedy
• The UPI used to control DECODE did not end
normally.
• Replace the fax PCB.
##238 (reception) PRINT control unit malfunction
Cause Remedy
• The UPI used to control PRINT did not end
normally.
• Replace the fax PCB.