Specifications

CHAPTER 5 ERROR CODE
5-10
COPYRIGHT
©
1999 CANON INC. CANON SUPER G3 FAX BOARD-F1 REV.0 MAY 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
##201 (transmission/reception) DCN received outside normal binary procedure
Cause Remedy
• The other party is not ready to receive data.
(no recording paper)
• The user TEL has not been registered (the
other device is RICHO 3000L).
• The password does not match for polling
reception.
• No original is set for transmission.
• Reception was attempted, but recording paper
does not exist.
• The condition of the line is poor, and the other
device cannot receive procedure signals prop-
erly.
• An echo caused malfunction.
• Image signals or Q signal cannot be received,
and the other (transmitting) device suffered an
excess procedure signal re-transmission.
• The condition of the line is poor, and the other
device cannot use a fall-back.
• Request the other party to make the other
device ready for reception. (by setting record-
ing paper)
• Register an appropriate user TEL.
• If the other device is of the same model, contact
the other party to match the passwords. If the
other device is a non-Canon device, contact the
other party to set the device for polling transmis-
sion.
• Set an original, and request the other party to
ring once again.
• Set recording paper.
• Raise the transmission level of the modem using
parameter 07 of #2 MENU so that the other
device may receive the procedure signals
properly.
1. Provide measures against echoes by referring to
the descriptions under #1 SSSW SW03.
2. Lower the transmission level of the mode using
parameter 07 of #2 MENU so as to prevent
reception of echoes.
1. Request the other party to raise the transmission
level of the other device so as to enable correct
reception of signals.
2. Adjust the NL equalizer using parameter 05 of
#2 MENU so as to enable correct reception of
signals.
3. Request the other party to lower the transmission
start speed of the other device.
1. Relax the RTN transmission condition using 02
through 04 of #3 NUMERIC Param. so as to pre-
vent transmission of RTN.
2. Adjust the NL equalizer using parameter 05 of
#2 MENU so as to ensure correct reception of
signals.